- 非IC关键词
深圳市鼎集电子
- 营业执照：未审核身份证：已认证经营模式：经销商所在地区：广东 深圳
收藏本公司 人气：104222
企业档案
- 相关证件：
- 会员类型：普通会员
- 张小姐
- 电话：0755-82723971
- 手机：13590301695
- 地址：福田区振华路高科德电子市场一楼13311
- 传真：0755-25039973
- E-mail：591509948@qq.com
供应色环电容，ACC-Y104M500P52
色环电容，ACC-Y104M500P52
国产
无铅*型
直插式
盒带编带包装
普通/民用电子信息产品
轴向引线型
圆柱体型
产品信息
| 品牌： | 国产 | 型号： | ACC-Y104M500P52 |
| 介质材料： | 独石 | 应用范围： | 耦合 |
| 外形： | 圆柱形 | 功率特性： | 小功率 |
| 频率特性： | 中频 | 调节方式： | 固定 |
| 引线类型： | 轴向引出线 | 允许偏差： | ±20（%） |
| 标称容量： | 100000PF | 损耗： | 0.035 |
| 额定电压： | 50（V） |
电气性能标准THE STANDARD OF THE ELE*RICAL PROPERTICAC
|
检验项目 ITEM |
检验标准 T*T STANDARD |
||||||
|
NPO(N) COG（CG） |
X7R(B) |
Z5U(E) |
Y5V(Y、F)
|
||||
|
电容量(C) Capacitance |
在相应的误差 范围内 In the tolerance |
在相应的误差 范围内 In the tolerance |
在相应的误差 范围内 In the tolerance |
在相应的误差 范围内 In the tolerance |
|||
|
损耗角正切(DF) Dissipation Factor |
CR≥50pF DF≤0.15% CR<50pF DF≤1.5[(150/CR)+7] ×10-4 |
≤3.5% |
≤5% |
≤3.5%(150000PF以下) ≤10%（22PF） ≤15%（48PF） |
|||
|
*缘电阻(IR) Insulation Resistance |
C≤ 10nF R>10000 MΩ C> 10nF R．C> 100S |
C≤ 25nF R>4000 MΩ C> 25nF R．C> 100S |
C≤ 25nF R>4000 MΩ C> 25nF R．C> 100S |
C≤ 25nF R>4000 MΩ C> 25nF R．C> 100S |
|||
|
耐电压 Dielectric Withstanding Voltage |
2．5倍额定电压 2．5×rated Voltage |
2．5倍额定电压 2．5×rated Voltage |
2．5倍额定电压 2．5×rated Voltage |
2．5倍额定电压 2．5×rated Voltage |
|||
|
测试条件 T*T CONDITION |
|||||||
|
测试频率 Test Frequency |
100kHZ (C>1000PF,1KHZ) |
1KHZ |
1KHZ |
1KHZ |
|||
|
测试电压 Test Voltage |
1±0．2VDC |
1±0．2VDC |
0．3±0．2VDC |
0．3±0．2VDC |
|||
|
*缘电阻测试电压 Test Voltage of IR |
额定电压 Rated Voltage |
额定电压 Rated Voltage |
额定电压 Rated Voltage |
额定电压 Rated Voltage |
|||
|
环境温度 Temperature |
18℃～25℃ |
18℃～25℃ |
18℃～25℃ |
18℃～25℃ |
|||
|
环境湿度 Humidity |
< 75% |
< 75% |
< 75% |
< 75% |
|||
|
温度系数 Temperature Coefficient |
0±30ppm/℃ -55℃to +125℃
|
±15% -55℃to +125℃ |
+22% to–56% +10℃to +85℃ |
+30% to-80% -25℃to +85℃ |
|||
品质检验项目及*性试验QUALITY INSPE*ION AND RELLABILITY
|
项目 ITEM |
检验标准 T*T SPECIFICATIONS |
检验方法 T*T METHODS |
||||||
|
可焊性 Solderablity
|
引线表面均匀沾锡,上锡面积不小于总面积的75%。 Lead wire shall be soldered with uniformly coated on the axial or radial direction over 3/4 of the circumferential direction. |
将电容器引线浸入含25%酒精（或异丙醇）的松香溶液后浸入焊接槽温度为235±5℃的焊锡中2±0.5秒，浸入深度距离电容体2.5～3.0mm。 The lead wire of a capacitor shall be dipped into a 25% methanol solution of rosin and then into molten solder of 235±5℃ for 2±0.5 seconds ,in both cases the depth of dipping is up to about 2.5 to 3.0 mm from the root of lead wires. |
||||||
|
耐焊性 Resistance To soldering heat
|
外观 Appearance |
*伤 No marked defect |
焊锡温度265±5℃，时间5±0.5秒，*深度距离电容体2.5～3.0mm，*速度1秒，试验后2～24小时测量。 The lead wire shall be immersed into the melted solder of 265±5℃，up to about 2.5 to 3.0mm from the main body for 5±0.5 sec and the specified items shall be measured after leaving for 2 to 24 hours. |
|||||
|
容量变化ΔC/C Capacitance change |
NPO:≤5% X7R:≤-5～+10% Y5V:≤-10～+20% |
|||||||
|
介电强度（引线间） Dielectric strength（between lead wires） |
不失效 No failure |
|||||||
|
耐久性 List test |
外观 Appearance |
无外观损伤 No marked defect |
条件 Condition |
NPO |
X7R |
Y5V |
Z5U |
|
|
容量变化ΔC/C Capacitance change |
NPO：≤2% X7R：≤20% Y5V：≤30% |
温度 Temperature |
+125℃ |
+85℃ |
||||
|
D．F. |
NPO：≤0.3% X7R：≤5% Y5V：≤7% |
时间 Time |
t=1000h |
|||||
|
R．C>25S |
电压 Voltage |
V=1.5Vr |
||||||
|
恢复时间 Recovery time |
24±1h |
|||||||
|
引出端强度 Strength of Lead temination |
拉力 Pull |
引线不断 电容器不破损 Lead wire shall not cut off. Capacitor shall not be broken. |
如图：固定电容器并加力，引线直径0.5mm以上加力3kg，保持5秒 As a figure, fix the body of capacitor, apply a tensile weight gradually to each lead in the radial direction of capacitor up to 2 okgf, and keep it for l to 5 sec. |
G |
||||
|
折弯 Bending |
引线负荷0.5kg向一方向折弯900后恢复原位，再向反方向折弯900恢复原状为，共3次。 Each lead wire shall be subjected to 0.5kgf weight and then a 900bend at the point of egress, in one direction, return to original position and then a 900bend in the opposite direetion at the rate of one bend. |
|||||||